Quick Connect Water Inlet Specifications & Fit Checks

• Material: solid 316 stainless steel.
• Connection: Flushmaster male Quick Connect with locking cap and chain.
• Flange: 2-3/4 inches; three-hole mounting pattern.
• Hose connection: 1/2-inch barb installed; 3/8-inch barb included.
• Seal: double O-ring connection and molded rubber mounting gasket.
• Confirm mounting opening, screw spacing and rear clearance before installation.

Have a qualified marine technician confirm the inlet’s application and existing plumbing before installation. Compare the opening, flange, screw spacing, mounting support and clearance behind the panel.

Match the included 1/2-inch or 3/8-inch barb to the approved internal hose. Use suitable marine hose clamps and mounting hardware for the boat; inspect the hose condition and test the completed connection for leaks.

For an existing engine-flush reroute, preserve a separate approved route to each engine and all required engine safeguards. This fitting alone does not create a reroute or an automatic flushing system.